Windsor D250 (115V) Manual do Utilizador

Read these instructions before operating the machineMODEL: D250 (115V)Beginning with Serial No. 100005453798828 06/07/03PCARPET EXTRACTOROperating In

MAINTENANCE & TROUBLESHOOTINGD-250 98828 04/08/039D-250 PUMP MAINTENANCEPer manufacturer’s recommendations the following maintenance should be

TROUBLESHOOTING CONT.D-250 98828 04/08/0310Solution hose Corrosion on fittings Clean with steel wool. fitting hard to Soak in acetic acid

115V WIRING DIAGRAMD-250 98828 06/07/0311

D-250 98828 04/08/0312THIS PAGE LEFT BLANK INTENTIONALLY

RECOVERY TANK ASSEMBLYD-250 98828 06/07/03132021141718193616131591211103583474652312223242513132927282630313233

RECOVERY TANK ASSEMBLYD-250 98828 06/07/0314REF PART NO. QTY DESCRIPTIONSERIAL NO.FROMNOTES:1 05151 1 TUBE ASM, RECOVERY TANK2 500009 1 LABEL, WARN

SOLUTION TANK ASSEMBLYD-250 98828 06/07/031512A39444215181940412021221417161354454643314751764849523523837383626A2730282425313429333211103198765141

SOLUTION TANK ASSEMBLYD-250 98828 06/07/0316REF PART NO. QTY DESCRIPTIONSERIAL NO.FROMNOTES:1 85045 1 VAC MTR ASM, D/B SLTN 115V 2ST2 39582 1 HOSE,

SOLUTION TANK ASSEMBLY CONT'.D-250 98828 06/07/0317REF PART NO. QTY DESCRIPTIONSERIAL NO.FROMNOTES:54 70232 2 SCR, 10-32 X 3/8 FHMS SS55 57196

Windsor Industries reserves the right to change its warranty policy without notice – Rev2 10/16/02 1WINDSOR INDUSTRIESNew Machine WarrantyLimited W

TABLE OF CONTENTSD-250 98828 04/08/031Data Log/Table of Contents...1Safety Instructions ...2Grounding Instruct

Windsor Industries reserves the right to change its warranty policy without notice – Rev2 10/16/02 2WINDSOR INDUSTRIESNew Machine Warranty90 Day Wa

SAFETY INSTRUCTIONSD-250 98828 11/09/002IMPORTANT SAFETY INSTRUCTIONSWhen using an electrical appliance, basic precautionmust

GROUNDING INSTRUCTIONSD-250 98828 04/25/023THIS PRODUCT IS FOR COMMERCIAL USE ONLY.ELECTRICAL:The amp, hertz, and voltage are listed on thedata lab

OPERATIONSD-250 98828 04/08/034CARPET INSPECTION:Determine precisely what areas you are going toclean. Note problem

OPERATION D-250 98828 04/08/035HEATER OPERATIONThe disconnect fittings on theheater will become extremelyhot during operation. Allow sufficient time

MAINTENANCED-250 98828 04/08/036DAILY MAINTENANCE:(At the end of each working day) :1.) Flush the entire system, including floor tool,hand tool, etc

MAINTENANCE D-250 98828 04/08/037SERVICE SCHEDULEMAINTENANCE DAILY WEEKLY QUARTERLYCheck machine for cord damage*Check recovery dome and gasket for

MAINTENANCED-250 98828 04/08/038! WARNING:ONLY QUALIFIED MAINTENANCE PERSONNEL ARE TO PERFORMTHE FOLLOWING REPAIRS.VACUUM MOTOR REPLACEMENT1. Turn o