Windsor CSC20 Instruções de Operação descarregar pdf (Página 41)

Maintenance

Do not use a pressure washer to clean around the brush motors. Use tap pressure only.

N’utilisez pas de nettoyeur haute pression pour nettoyer autour des moteurs des brosses. Utilisez

seulement la pression du robinet.

To Replace Scrub Brush Motor-Cylindrical

1. Lower scrub deck using selector knob. Turn off key in down position.

2. Disconnect the two connectors from solenoid valve.

3. Remove squeegee assembly.

4. Remove front bumper, 2 bolts.

5. Remove four front bolts connecting deck lifting arms to front of machine.

6. Remove actuator lifting pin and washers.

7. Remove solenoid valve and cover, 2 screws.

8. Disconnect motor plug from harness.

9. Slide deck out from under machine on right side, orientation is determined from operators view.

10. Remove metal cover over motor by removing 10 screws mounting to deck.

11. Remove screws mounting motor to drive housing and remove motor.

12. Reverse steps to install.

86359770 - CS20 SCRUBBER

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 55 56

Sem comentários

Windsor CSC20 Instruções de Operação Página 41