Windsor SCX364 Instruções de Operação descarregar pdf (Página 18)

100

101

Operations

Double Scrub

For floors which are heavily soiled or have thick accu-

mulations of floor finish may not clean sufficiently with

one pass. In these cases it will be necessary to double

scrub.

1. To double scrub, make the first pass over the

surface being cleaned with both squeegees up,

vacuum off, the solution on and brushes down.

This allows the solution to stay in contact with the

soil while loosening the surface accumulation with

the brushes. Allow time for the first application to

stay in contact with the floor. Length of time

between the first and second pass depends on

amount of accumulation and the type of chemical

being used. A second scrubbing with both

squeegees down and again the solution and

brushes on will further loosen soil. The additional

application of solution will further assist the difficult

cleaning job.

FOR SAFETY: When using machine, go slow on

inclines and slippery services.

Emptying And Cleaning Tanks

1. Park the machine next to a floor drain. Drain hose

is on left rear corner of the machine.

2. Turn the machine power off and set parking brake,

if your machine is equipped with this option.

Solution Tank

1. Loosen small drain hose from the retainer, then

lower hose in direction of the drain.

2. Remove the solution tank cover.

3. Flush the solution tank out with clean water and

run several gallons of clean water through

systems. Do not use water hotter than 140°F

(60°C) to clean tank. Damage may occur.

NOTE: Never allow solution to remain in tank.

Damage to tank, seals and valves could occur.

4. Secure drain hose into the retainer.

Recovery Tank

1. Unhook the large drain hose from the retainer.

Lower hose in direction of the drain then unscrew

the T-handle on plug enough to loosen plug. Do

not stand in front of end of hose. Recovered

solution will come out with force. Slowly remove

plug from drain hose.

2. Remove the recovery tank dome. Flush the

recovery tank out with clean water. Do not use

water hotter than 140°F (60°C) to clean tank.

Damage may occur.

3. Clean off the float shut-off system and inspect for

free movement of float. The float shut-off system is

located in the rear of the recovery tank.

4. Replace the drain plug and secure drain hose in

bracket.

5. If machine is to be stored, leave the recovery tank

dome off.

86037150 SCX364

SOLUTION

TANK DRAIN

TANK COVER

RECOVERY

TANK DRAIN

RECOVERY

TANK COVER

SOLUTION

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 100 101

Comentários a estes Manuais

Sem comentários

Windsor SCX364 Instruções de Operação Página 18

Comentários a estes Manuais

Manuais e produtos relacionados com Esfregão Windsor SCX364