Windsor SCX364 Instruções de Operação descarregar pdf (Página 27)

100

101

Maintenance

Solution Strainer

The solution strainer is located in front of the left front

wheel. The solution strainer protects the solenoid valve

from debris. If there is little or no solution flow to the

ground, check the strainer for debris. Drain the solution

tank and clean the solution strainer. To remove the

strainer, turn the bottom part of the strainer counter-

clockwise until the bottom is separated. Clean out the

debris from the wire mesh and re-assemble. Make sure

the O-ring gasket is in place when re-assembled

Brush Motor

Do not use a pressure washer to clean around the

brush motors. Use tap pressure only.

Changing Brush Motors

1. With the scrub deck in the stored position, discon-

nect brush motor wiring connector from harness.

2. Remove shrouds from scrub deck to access and

remove scrub brushes or pad drivers.

3. Remove retaining bolt, lock washer, flat washer

and star drive from brush motor shaft.

4. Remove 4 brush motor mounting bolts located

under scrub deck.

5. Remove brush motor.

6. Reverse steps to install.

Brush Motor Carbon Brush Replacement

1. Remove the cover from the top of the motor by

removing the three screws.

2. Note the alignment mark on motor barrel to motor

cap. Remove three bolts.

3. Remove end cap with brushes from motor.

NOTE: Motors contain two wave washers in cap. Do

not lose these.

4. Install the new end cap with brushes and realign

with scribe marks on motor barrel. Reinstall the

three attach bolts from cap into base.

5. Maintain alignment between motor barrel base and

cap.

6. Install the cover on top of the motor with the three

screws.

86037150 SCX364

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 100 101

Comentários a estes Manuais

Sem comentários

Windsor SCX364 Instruções de Operação Página 27

Comentários a estes Manuais

Manuais e produtos relacionados com Esfregão Windsor SCX364