Windsor CBE20 Instruções de Operação descarregar pdf (Página 18)

Operations

Pre-run Machine Inspection

Do a pre-run inspection to find possible problems that

could cause poor performance or lost time from break-

down. Follow the same procedure each time to avoid

missing steps.

NOTE: See maintenance section for pre-run machine

inspection checklist items.

Starting Machine

NOTE: Perform pre-run machine check before

operating machine.

FOR SAFETY: Before starting machine, make

sure that all safety devices are in place and

operating properly.

1. Disconnect the battery charger.

2. Close the cover.

3. Turn or install a new burnishing pad as needed.

4. Stand on the operator platform. Throttle pedal must

be in neutral position.

5. Turn the machine power on by turning key switch

clockwise to the “ON” position.

6. Check the position of the Directional Control

Switch to make sure the machine will travel in the

direction intended.

7. Press the Drive Reset Switch.

8. Press lightly on the throttle pedal with right foot.

Operating the Machine

1. Lower or raise deck by pressing burnishing head

switch.

2. The pad motor will only run when the burnishing

head is lowered to within 2 inches of the floor.

3. The pad pressure is adjusted using the pressure

switch at right of panel. The operator monitors the

amp draw using the meter located on the control

panel and ensures that the needle remains in the

“green” operating range.

To prevent possible damage to the floor surface,

always keep the machine moving while the pad is

spinning.

4. When the head is down and the machine is

propelled, the pad motor runs.

5. Return the machine to the battery charger when

the battery light indicator meter indicates

discharged batteries

Emergency Stop Procedure

Release the throttle pedal by lifting right foot.

Turn machine power off with key switch, by turning key

switch counterclockwise.

If an electrical problem is suspected, push in

emergency stop button. This will also engage the

parking brake and cause the machine to stop immedi-

ately.

86345050 Chariot Burnisher

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 105 106

Comentários a estes Manuais

Sem comentários

Windsor CBE20 Instruções de Operação Página 18

Comentários a estes Manuais

Manuais e produtos relacionados com Esfregão Windsor CBE20

Související produkty a manuály pro ne AEG L6FSU741K